Jig machine is fixed sieve type, suitable for separating metal ores, such as tungsten and gold bearing ore, selecting tin ore, etc. Jig machine can be used for selecting fine grain materials as well as coarse materials, the big feeding size is 6-8mm, but in the individual case of separating ore, the big size is 12mm.The maintenance of the machine is an important and regular work, which should be operated and overhauled and so on in close co-operation, there should be Specialised personnel to carry out on-duty inspection. The installation and maintenance of jigger is also very important.

Installation trial

1、The equipment should be installed on a horizontal concrete foundation and fixed with ground bolts.

2、When installing, attention should be paid to the verticality of the main body and the level.

3、After installation, check whether the bolts of each part are loose and whether the hatch of the main machine is tightened, if so, please tighten it.

4、Configure the power line and control switch according to the power of the equipment.

5、Check out, carry out empty load test run, test run can be normal production.

Equipment maintenance:

1, the newly installed wheel hoop is easy to loosen must be frequently checked.

2, pay attention to the machine parts of the work is normal.

3, pay attention to check the degree of wear and tear parts, pay attention to the replacement of worn parts at any time.

4, put the movable device of the base frame plane, should be out of dust and other things so as not to meet the machine can not be crushed materials when the movable bearings can not move on the base frame, resulting in serious accidents.

5, bearing oil temperature rises, should stop immediately to check the cause to eliminate.

6、Rotating gears in operation if there is a shock sound should be immediately stopped to check and eliminate.